SickoTeg

Hi im running a d16y7 with a (si) d16y8 wiring harness and ecu.. My question is d16y7 doesnt have vtec so i keep getting the check engine light code 22 (vtec) How would i trick the comp to think there is a vtec so the check engine goes away..


And also with the check engine light on is the car in disable mode? Wich means i cant rev past 5500 rpm?

b18bHatch

get a new wiring harness & ecu....with no vtak

SickoTeg

rigghhhhttttt


but my vtech is so vteching without vtech..

b18bHatch

the vtak part is a joke and so is this post, get an ecu ment for a non vtec

SickoTeg

you odnt know what your talking about..
Then i would have to run 3 wire iacv.. And add extra wires to ecu pointless..
im asking advice from people that know what they are doing..

zeeman

iTrader: (1)

well if the ecu was in limp mode it wouldn't be able to rev past 4000rpms....but having the CEL on doesn't always throw the car into limp mode.
Not sure if you could trick the ecu into thinking there is no vtec, unless you remove the vtec components from the ecu (or specifically just the 5151 high side switches)....but i'm not even sure if that would work....i know on an obd1 ecu, all you'd need to do is remove the 5151 high side switch and cut j10 and obviously run a non-vtec program on the chip.

SickoTeg

im thinking best bet convert to obd1 and run po6 ecu...

imported_chris_v2

actually he does. You're the guy is running a vtec ecu with a y7. Just put in a y7 ecu.. pretty simple.

b18bHatch

Double_B

Lets keep it on topic or this thread gets closed