imported_2join performance

Hey guys,
Recently I have completed an auto to manual swap, but I have one issue that bothers me. I dont believe its normal.
Basically my clutch engages like 1cm off the floor, maybe less. It's pretty much instant engagement. Then once it is fully released there is some freeplay at the top, maybe 3-5cm of what feels like an improperly bled clutch. So what happens is I will release the clutch, it will instantly grab, and then I continue releasing it. Once my foot is of the clutch pedal, the pedal will pop up and its in the free play zone.
I dont know what the problem is. I thought it might be improperly bled, but it doesnt seem like it, and the fluid is topped up. Maybe there is a way to adjust the engagement point like on cable trannies? Or maybe I messed up during the install?
All help is greatly appreciated. Thanks.

gooseshit

bleed the clutch

dingus888

^^^wrong

adjust clutch pedel assembly you have way to much free play

imported_2join performance

Ya, I do not think that I have to bleed the clutch because there is resistance, its just not in the right place.
As for adjusting the pedal assembly, how do I do that? Is there a screw somewhere? Or do I unthread one of the sensors?
Thanks.

imported_italstallion

its a gold bolt at the very top of the pedal assembly and u tighten it accordingly but it you tighten it too much where the clutch is engaged say bye bye to clutch

imported_2join performance

Alright, I will have to give that a try. So I am assuming that I need to loosen that bolt since mine is basically engaging right at release right?