KPD

my passenger window fell of the track
i can't seem to put it back on i took off the door panel and not quite sure what to do now
the power widnows still work just can't do it up sinc eit's not on the track

plz provide some help asap

THANKS

Cantonagod

Loosen the screws, place the window inside the track while making sure that it is in the vertical guide inside the door , shift it so the screws move into the narrow side of the hole , tighten the srews, move the up before putting the door panel back on to make sure it works.

starman

After you are done doing what was described above here is how to prevent this from happening again. Go to CT and buy a can of silicon lubricant ($7). It should come with a tiny straw.

With the door panel still off, get the straw inside the track as far as you can and spray first at the bottom of the track with window up (very short squirt), than move about 3-4 inches higher and do a same thing again as high as you can on BOTH sides. Move the window down and do the same from the bottom of the window opening to the top. Remember very small squirts on both sides. Once you are done move the window up and down a number of times. You will see a significant improvement in speed as well as preventing future pop outs. I have done this about 7 months ago and no problems since.

Once I did it on my first window I had to do it on the other one because it made a big difference on the very slow Honda windows.

Hope it helps

j_limitz

hey that happened to me as well and i did what these guys described and it worked...for a bit...then it came undone again...just make sure when it is fixed that you don't close the door hard when the windows are down or you may have the same problem again...

KPD

yea just fixed the problem

but when i rool it up it makes a squeaky noise now!

i dunno

i'll try to fix it later i guess

thanks for the help