imported_JTRUDEL90

hey i have a quick question ............how to remove the shifter linkage from the transmission it looks like its got a steel band....like a hose clamp..... around the linkage ..............i'm trying to replace the rubber boot


Thanks for the help

JUSTIN

chris_si98

pull back the rubber boot.. remove the c-clip and get an 8mm punch and punch the **** out of the bitch pin or if you have access to an air chisel.. that would be the best option

right zeeman? lol

zeeman

iTrader: (1)

air chisel is your best friend.
The bitch pin is a PITA....hence why its called the bitch pin.
The little c-clip may seem invisible...right chris? lol
But actually its quite visible and needs to be removed first to have access to the bitch pin.
Good luck.
Don't forget to remove the 12mm bolt that holds the stabilizer bar to the tranny.

chris_si98

just make sure you don't use weak objects to try to knock the pin out of place. Sometimes objects such as nails or screws will fit perfectly.. but they will snap off. But only torqueless guys tend to break weak objects in there and get it stuck and leave it for the big powerful boost ****** to take it out the next day.

imported_goaT

**** it took me like 20 mins to knock that bitch out and laying under the car, my neck felt like a btich after. good luck

newman

Sounds like a story is behind this