Muffler Fitment
#23
Well its all in, and it is friggin awesome.
heres how the fitment was
the "S" bend in the B-pipe is too close to the center of the car, so lining that up in its correct spot places the flange 2-3" short of the cat flange. to correct this (and to keep the hangers in the correct spots), the shop cut the b-pipe just downstream of the resonator and welded in a 2-3 inch piece to lengthen it. this is all the mods that were needed to get it to bolt up to a USDM EX (CDM Si)
i also had the tip extended about 2 inches, as it barely reached the inside edge of the bumper. i should have some pics up tomorrow.
heres how the fitment was
the "S" bend in the B-pipe is too close to the center of the car, so lining that up in its correct spot places the flange 2-3" short of the cat flange. to correct this (and to keep the hangers in the correct spots), the shop cut the b-pipe just downstream of the resonator and welded in a 2-3 inch piece to lengthen it. this is all the mods that were needed to get it to bolt up to a USDM EX (CDM Si)
i also had the tip extended about 2 inches, as it barely reached the inside edge of the bumper. i should have some pics up tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
eddiemj
Interior - Audio - Security
5
03-Jan-2008 01:28 PM