imported_dragon208

finally just finish all the wirings for the mpfi swap.. it was soo hard and confusing with the instructions i found on tcc and on the internet.

I think all the wirings are done rite, plug the SI ECU on and cranks but apparently theirs no sparks though.. what is realli messed is after i crank and i let it go, my gas door makes a popping noise.. so i opened it and let go of the pressure and did it again and it's fine but no sparks still..

I have a 90SI distributor installed brand new from Honda. Sparks plugs, and distr cap and rotor were just changed couple months ago... everything else seems good but there's no sparks when i crank.. can any1 help me out..

have a SOHC ZC tryin to do a MPFI swap from a 90 CX..

Followed most of the wiring from here!

http://www.50mod.com/fourthgenhatch/mpfi.html


any1 have these kinds of problems after doing a mpfi swap?