imported_SpoonEr

I just replaced my ignition on a 1990 civic h/b. everything that I unplugged I plugged back in, but now I can not get the car to start. It is as if there is now power going to the starter, when hte turn the key on all acccessories work, it just won't crank.

Any help would be great.

Thank you

Si98

did you check your fuses?

imported_SpoonEr

I checked both sets of fuses, under hood and under dash.

Si98

check your connections again. could also be a bad ignition switch.

imported_SpoonEr

I have double checked the connectors and the swapped out the wiring, and then double checked that, still no go.

imported_starboy869

Did you clean your ground wire connection from the battery to the transaxle?

Also check to make sure the single wire is clipped in on your starter.

imported_SpoonEr

I will give that a try

imported_SpoonEr

there was a broken wire inside the ignition harness, casing was intact. just thought I would let everybody know, thanks for all the help

zeeman

iTrader: (1)

its good that you put what the problem is. Its useful for when people are searching for help.