imported_Joker

I tried to install my line level convertor , but ran into a few problems, i don't think they are related to the line level tho.

1) i hooked up my amp , but everytime i put in the fuse under the hood, the fuses (2x20 amp) on the amp blow, and the same happens when i do the amp fuses first. I disconnected everything and tried again
my ignition wire going to my stock deck is attached to the remote wire going to the amp, which is controlled by a switch. I disconnected the remote wire from the deck and the amp and now my deck does not want to turn on.
It will light up when i turn the headlights on but the radio wont play, it wont turn on.

Is there a fuse in the stock deck that may have blew? Or is my amp blown? How could i check if my amp/ deck are blown?
any thoughts on how to fix this?

thanks

imported_Joker

anyone?

imported_loudsubz

if you have disconnected everything from the amp except GND and + then its something on your amp

imported_Joker

ok, now when i hook it all back up the fuse for the radio blows, the two on the amp and the one under the hood are fine, when the remote is hooked up, the radio fuse blows but the amp still doesnt rn on

imported_Joker

if my amp doesnt turn on , does that mean its fried? cause when i only had the power and gnd connected, evrything was fne, nothin blew....

is it possible to obtain a spare honda harness?

imported_Joker

i give up on this... i think my amp is blown .. *&*#^$%#*#(

imported_Audio Heaven

Hi,

Swing on by our shop and we can have a look for ya

Thanks

Jeff Try
Audio Heaven Inc.

905 780 9656