zc ecu question
#1
zc ecu question
im doing a dohc non vtech swap now when i chage the computer do i have to change the wiring harnest as well .....might be a stupiq question to ask but it is a question never the less??
#2
I think you can use the stock crx SI harness for pretty much everything. I know that the distributor & clip requires some mods, not sure what exactly though..
Make sure you run it on the PM7 Ecu, makes a big difference over the PM6.
Make sure you run it on the PM7 Ecu, makes a big difference over the PM6.
#3
k
What is the difference between the pm7 and pm6...i was offered a pg7 ecu but i did some research on it and i found out that the engine was running very rich....if i do decide to go with the pg7 i have to change the injectors , and o2 sensor...also my question with that is that if i go for emissions and i use the pg7 ecu will it fail sinch its idling rpm will be 1200 to 1500
#4
No real difference, the Pm7 runs more accurate fuel/ignition maps for the DOHC ZC.
I'm not sure but i think it was only the 90-91 PM6 could be chipped to be like the Pm7.
You should check out TheZCR.com
It's a forum based solely on ZCs!
I'm not sure but i think it was only the 90-91 PM6 could be chipped to be like the Pm7.
You should check out TheZCR.com
It's a forum based solely on ZCs!
Thread
Thread Starter
Forum
Replies
Last Post