imported_B16_EG

the place where i co-op has a b17 gsr engine and they would sell it to me for cheap, and i own a 1993 h/b by the way, and i was thinking about buying this from them, i know i will need a b16 tranny and ecu (dont know what one) and to get integra mounts, but what else would i need and where to get all this stuff from and how much would each cost (roughly speaking) what are your oppinons on this and what should i watch out for? thanx

imported_Thrill_House

OH man thats a good, and also rare motor!

Younes Si

what you have and what you could have.....go for it

92JDMx

if it is just swapin 1.8 GSR u will just need the rear engine mount, rewire for vtec...

Scott-93HBSi

you'll also need to change out your Timing belt block mount. the 2nd gen integra ones don't work in EG/EK's. Either a 94+ integra mount, or 92+ B16A mount will work for you.

I have the mounts - pm me if you need them.

imported_B16_EG

yea i was thinking about getting the 94+ mounts, i would get them off you but this wont be for a while, i have to sell my other car first for the money, i was just wondering what everyone though, i really like it cuz its really rare.

zeeman

iTrader: (1)

you can use the obd1 p72 gsr ecu or a chipped p28.

imported_B16_EG

so far i will need : Inegra mounts, b16 tranny, chipped p28 , rewire for my vtec? and Timing belt block mount, is that all? where can i find these and how much for each (rough estimate)

imported_climax

wow that would rock.. go for ittt