MonoDJ123

I'd like to know which wire do I connect my air/fuel guage sensor wire to. In the instructions it said to connect the wire after the connector. There are 4 wires white,orange,green and another one. I connected my guage to the white one it looks like it working but after the guage starts working and I drive the reading on the guage goes everywhere. I reads rich to lean in seconds and keeps on flapping around none stop. But when I floor it it goes to rich and stays a little but later it keeps on flapping to rich and lean none stop. Do you guys have any ideas?

MonoDJ123

You all should know that I'm talking about the oxygen sensor wiring right? The air/fuel guage needs to connect to that signal wire from the oxygen sensor.

xenon_194

A/F guage will do that, I haven't done an instal myself, but my buddies A/F guage does that. During normal driving, the light bounces back and forth like a arcade game sign, but during hard acceleration, it reaches its lean or rich zones(w/e ur car is running). For the wiring, maybe someone can confirm ur connection

imported_Slvr-Bullet

This is what it's suppose to do when driving around normally


Here's some info on how it operates.

And here's an install instructions for reference.

Chigga1

yah thr flapping = RICE LOOK! hahaha jokes,

i had it that gauge on my Neon... it did that till my foot was buried on the floor, the thing was read RICH like HUGH HEFFNER!

but during idle it was lean that stoich that flaps!
its like that!..... i gotta read up on it... the gauge is alot more useful on turbo cars... stays consistant! till the the gas pedal is let off..... just take it as a screen saver!