**WIRING** DX to Si
#1
**WIRING** DX to Si
Well the crossmember is on and the seteering is working like a charm now it's time to get the motor in but I might have a problem.
I have the engine wiring but I am missing the three harnesses that go in the plugs next to the fuse relay.
Do these harnesses just plug into the old DX plugs ?
Or do I have to move a couple of pin locations ?
I have the Si computer and I know that the computer plugs right in.
So there's your question's.
I have the engine wiring but I am missing the three harnesses that go in the plugs next to the fuse relay.
Do these harnesses just plug into the old DX plugs ?
Or do I have to move a couple of pin locations ?
I have the Si computer and I know that the computer plugs right in.
So there's your question's.
#2
I'll be most likely doing this too:
http://hybrid2.honda-perf.org/tech/sohcvtec.html
http://www.4thgenerationcivic.com/ho...conversion.htm
http://hybrid2.honda-perf.org/tech/sohcvtec.html
http://www.4thgenerationcivic.com/ho...conversion.htm
#5
Well I was one step ahead of ya.
I went out and bought the chilton manual ( cuz the haynes manual didn't have the diagram).
While I was there I bought the stuff I needed to complete this step and guess what 6 hours later here I am telling you that I have already finished this step.
Now to drop this motor in !!!!!!!!!!!!!!
I went out and bought the chilton manual ( cuz the haynes manual didn't have the diagram).
While I was there I bought the stuff I needed to complete this step and guess what 6 hours later here I am telling you that I have already finished this step.
Now to drop this motor in !!!!!!!!!!!!!!
Thread
Thread Starter
Forum
Replies
Last Post
imported_corcoran_chris
Interior - Audio - Security
5
11-Oct-2003 07:20 PM
imported_corcoran_chris
Chit-Chat
1
10-Oct-2003 09:58 AM