Superfly_2

I can't take out the driver (and passenger) door panel. There is only one screw that I found (the internal door handle that you use to pull the door shut). I remember someone telling me about clips, but I have no clue where to go from here.

Please help,
Thanks in advance,
~Andy

PS: Civics suck

Import Racer

first remove the speaker grill, then remove the screw from the pocket where you would close the door with, like what you mentioned. There should also be a dark colored screw close to the dash area on the door which you have to remove. After that, just pry it open. But becarefu not to snap the clips. The clips are located along the bottom and sides of the panel. After that, just lift up the panel a bit so it unhooks from the top where the window is. That's it.

Superfly_2

Thanks dude I'll try that

Legacy73

There are only 3 screws that need to be removed as well as the window crank clip and the panel clips which you can't see from the front.
1. remove window crank using screwdriver to remove C-clip
2. remove screw from little cup below door handle (the thing used to pull door shut)
3. open the door and you'll see a screw located near the top door hinge
4. pull the handle as if you were opening the door and you'll see the last screw tucked behind the lever
5. remove speaker grill
6. pull panel from the bottom topop the clips out behind the door panel.

imported_ryanhook

Actually fellas, you don't have to remove the speaker grille. Trust me, I've had my door panels off dozens of times.

imported_Clayton

Ryan's right, pulling the speaker grille is not necessary. It's the screw behind the door latch handle that most people miss....


Clayton

PULOVR

But it does make it a little bit easier to grab the lower door to yank it .

imported_ryanhook

Bah! Amateurs!