White Face Gadge + Switch Install HELP !
#1
White Face Gadge + Switch Install HELP !
new to the scene somewhat and i just picke up a Whiteface gadge setup that has a blue / green switch .. i wonder if there is any how to site to show me how i can install this bad boy tonite .. ASAP if possible .. Thank guys
#2
Guest
Posts: n/a
Here's a link but it only tells you how to remove the cluster.
http://www.honda-tech.com/zerothread?id=1054824
Once you have the cluster out, its pretty straight forward on how to get to the actual gauges. These steps I'm giving you, is my experience when I was installing them.
- Do not remove the needles!
- Make sure to remember where the gas needle indicator was last set, you will have to move it around when installing the white face and remember to place it back where it was.
- Do the speedometer and tach first, they're the easiest, the one that will give you most trouble will be the temp and gas gauge. Take your time with this one.
- If the holes do not go line up, get a very fine drill bit and adjust the holes until it fits.
- You will have to drill a hole at the bottom of the cluster so you can run your wires to the ground and power source.
- Best power source will be the dimmer switch, I can't remember which wire it was (there's only two there) on the dimmer switch. If you connect it to the one wire and it does not come on, its the other wire gauranteed. The gauges will come on when your parking lights, headlights come on.
- Use the double side tape thats
provided with the kit and apply under the white face gauges once you have everything installed. The gauges will be completely flat with the tape applied.
- Take your time.
I hope I helped you, just let me know if you have any more questions.
http://www.honda-tech.com/zerothread?id=1054824
Once you have the cluster out, its pretty straight forward on how to get to the actual gauges. These steps I'm giving you, is my experience when I was installing them.
- Do not remove the needles!
- Make sure to remember where the gas needle indicator was last set, you will have to move it around when installing the white face and remember to place it back where it was.
- Do the speedometer and tach first, they're the easiest, the one that will give you most trouble will be the temp and gas gauge. Take your time with this one.
- If the holes do not go line up, get a very fine drill bit and adjust the holes until it fits.
- You will have to drill a hole at the bottom of the cluster so you can run your wires to the ground and power source.
- Best power source will be the dimmer switch, I can't remember which wire it was (there's only two there) on the dimmer switch. If you connect it to the one wire and it does not come on, its the other wire gauranteed. The gauges will come on when your parking lights, headlights come on.
- Use the double side tape thats
provided with the kit and apply under the white face gauges once you have everything installed. The gauges will be completely flat with the tape applied.
- Take your time.
I hope I helped you, just let me know if you have any more questions.
Thread
Thread Starter
Forum
Replies
Last Post
civic_integra
Interior - Audio - Security
11
01-Aug-2005 12:53 PM