valve noise
OK- i have don some searching and haven't found an answer-
recently upgraded to s2s2 cams along w/ skunk2 valvetrain into b16. Had head milled .030". Now my ?- with the head shaved would I need to set the valve lash a little different from recommended specs-(o.o7 I and 0.08 E). I have tried a couple of different settings but cant get the valves to quite down. I checked timing belt for slap against cover-all good Checked and even swapped out inj.- no ticking inj. any other suggestions as to possible ticking. By the way the ticking increases w/ speed. The car runs fine except for at idle( mostly to blame on bad IACV). I'm just stumped, I want to get it sounding and running good before I get some tuning done. |
All times are GMT -4. The time now is 02:32 AM. |
© 2024 MH Sub I, LLC dba Internet Brands