valve noise
#1
valve noise
OK- i have don some searching and haven't found an answer-
recently upgraded to s2s2 cams along w/ skunk2 valvetrain into b16. Had head milled .030".
Now my ?- with the head shaved would I need to set the valve lash a little different from recommended specs-(o.o7 I and 0.08 E).
I have tried a couple of different settings but cant get the valves to quite down.
I checked timing belt for slap against cover-all good
Checked and even swapped out inj.- no ticking inj.
any other suggestions as to possible ticking. By the way the ticking increases w/ speed. The car runs fine except for at idle( mostly to blame on bad IACV). I'm just stumped, I want to get it sounding and running good before I get some tuning done.
recently upgraded to s2s2 cams along w/ skunk2 valvetrain into b16. Had head milled .030".
Now my ?- with the head shaved would I need to set the valve lash a little different from recommended specs-(o.o7 I and 0.08 E).
I have tried a couple of different settings but cant get the valves to quite down.
I checked timing belt for slap against cover-all good
Checked and even swapped out inj.- no ticking inj.
any other suggestions as to possible ticking. By the way the ticking increases w/ speed. The car runs fine except for at idle( mostly to blame on bad IACV). I'm just stumped, I want to get it sounding and running good before I get some tuning done.
Thread
Thread Starter
Forum
Replies
Last Post
thisissarcastic
Maintenance
3
12-Dec-2011 09:03 AM
drift_n_shift
Honda Civic (+ other) Parts/Accessories for Sale or Trade
0
14-May-2009 02:57 PM
imported_Eg_R
Honda Civic (+ other) Parts/Accessories for Sale or Trade
3
20-Feb-2007 08:05 PM