markpa

Whats this sensor for? Its got two plugs on it, and when i was taken it off i didnt notice that, so now, I dont know which wire goes to which plug, Theres a yellow and a black wire, The way i put it on is the yellow is closest to the tranny looking from the back, just like in the pic, and the black is closest to the alternator.

imported_94EG6HB

Back of the block near the oil filter..

Two pins sticking out..

You see it???

markpa

I know where it is, I just dont kno what its called, Or which wire goes to which pin

Cynikal.Mindset

oil pressure switch?

bbarbulo

iTrader: (2)

oil press has one pin

the two pin one may be coolant temp?

f22-dohc

i noticed this on the weekend doing a swap...

older b18 has it on the block, but not on the newer one we were puttin in.

1niceSi

This is good for me to know, because I'll be doing my swap this weekend...or atleast starting it.

*Mental note* label each and every connect upon disconnection.

markpa

from hondatech

"
the one with the rubber around it is for your thermo switch located by your oil filter . The other is for your knock sensor located above your oil filter right below intake manifold ."

It turns your fan on and off, appreatnly it doesnt matter which wire goes where.

imported_zc_hatch

^^^^^^^^

thats correct

scott newman

Fan stat switch

Brett

that is a bastard to plug in, i think it took me many, many tries!

Gunmetalef

its not that bad.. i just pulled it out of the black housing shoved em in there then put the cover back on

Brett

Guess im unlucky