is this motor rebuildable?
Have a motor that has gone to do lack of oil.
Can this motor be rebuilt? what usually needs to be changed? |
you have to do measurements in order to find out. If the there is too much taper, out-of-roundness or especially over-bore, I would junk it. Usually a good hone will clean up a bit of taper or out of roundness, but if its way over spec a bore and hone will be needed, then OS pistons, rings blah blah.
Or you could just have a spun bearing, which might of ate out a few of the journals (not good at all), but you won;'t know untill you tare it about. imo, if its a d-series, junk it. use it as a beer holder |
ok
|
All times are GMT -4. The time now is 04:38 AM. |
© 2024 MH Sub I, LLC dba Internet Brands