boostedcivic

Have a motor that has gone to do lack of oil.
Can this motor be rebuilt?
what usually needs to be changed?

imported_chris_v2

you have to do measurements in order to find out. If the there is too much taper, out-of-roundness or especially over-bore, I would junk it. Usually a good hone will clean up a bit of taper or out of roundness, but if its way over spec a bore and hone will be needed, then OS pistons, rings blah blah.

Or you could just have a spun bearing, which might of ate out a few of the journals (not good at all), but you won;'t know untill you tare it about.

imo, if its a d-series, junk it. use it as a beer holder

boostedcivic

ok