imported_ksyu1

Hey guys I just have a question..after I installed my HIDs, only 1 side came on..then I did some research and I removed my drl fuse and both sides started working..My question is..I saw 2 drl fuses ..one was just DRL and the other was DRL relay and I only removed the DRL fuse..should I also remove the DRL relay fuse? Any input would be great guys

bbarbulo

iTrader: (2)

i didn't have this problem at all. I never removed any fuses. you shouldn't have to if you wired it up correctly using a relay and the signal from your stock low beam wiring harness.

imported_ksyu1

ok you are absolutely right..I went out for a bit and found out that the same light stopped working again..Im sure its wired correctly.. Its wierd, im guessing the ballast is messed up

bbarbulo

iTrader: (2)

well troubleshoot it with a multimeter... trace your wiring and see where the power stops. if you have power at the ballast, but no output, then switch the left and the right ballasts and see if the problem moves with the ballast or stays on the same side. cuz it could be the bulb too...