xray

Speaking of which..I called Honda just out of curiousity for the price of the OEM fogs and was quoted $400+ for just the fog lights and $80+ for the switch. That $500 total. More curious, I asked how much to installed and was quoted $300+. So, you're looking at $800+. I fainted!!

Vinny

That's why you never go to a dealer for your work, only idiots who have this problem with trust. Honda charges like 100$/h for labour alone, plus the price of the products are multipled...but i won't lie the wiring system by Honda is quality compared to replicas because replicas are cost-effective. Besides the point, I know a few who bought from Honda and yet when i compare both cars it looks the same, the light quality is the same thought i do think the replicas might take a bit more power not 100% sure but when i was installing it, i noticed some power issues though maybe it was some problems with my wiring setup not to sure. Anyways the point is, Don't get stuff done at Dealerships, unless your under warranty/lease,etc.

matu

ok, i got it installed. dropped off the car b4 going to work & picked it up after i got off work. for the price i can't complain

xray

^Where did you end up going to for install?

matu

i ended up going to speedtech

_T_

That looks good! I was looking to purchase this style from ebay
http://cgi.ebay.ca/04-05-HONDA-CIVIC...QQcmdZViewItem

Has anyone purchased this style? Would it be simular to the original posters installation? If you did purchase this style from ebay, let me know, always good to know whos a good seller on there.

xxSLiMxx

iTrader: (1)

Nice install Xray!

xray

Thanks Jeremy! Would be nice if I could do the wiring as well, but no cigars. Lol.

Shreck

iTrader: (2)

I had no problem installing the lights in the bumper, that part went fairly well. I ran the wiring harness to the inside and that where the problem began. I am left with a 4 pin connector with two wires one black and one blue and no instructions on where it goes. The other single wire (brown connector) I plugged into the fuse panel

Did anyone else have this problem?

xray

It gave me a headache too, so I just took it into a shop.

Shreck

iTrader: (2)

I called a shop and they figure with at I have already done should cost about $45 if I dont need any more parts.

Here what they look like in yellow.

xray

They look sweet in yellow. I got it for both EMs. I was gonna switch over to clear, but glad I didn't.

$45 is good. Usually take them about an hour. Mine costs $60 with a few extra parts (i.e. wires, etc.).