imported_luvmycivic

Good Job

imported_hondalova

A tid bit more to add, because if you are a newb like me this will help in line the screw up.

If you can't see the screw, put key in ignition and turn on off quickly, it will rotate a quater turn with each crank and you will eventually line it up.

Also make sure you have correct screwdriver or you will strip the screw and will create more work.

jafferman

what if my old one never had a screw on it, what screw size to i use for my new rotor cap?

imported_Kingjames1983

Alright so this post was helpful today.. thanks a bunch and it couldn't have been easier.

Joey_Corrado

if u wanna make life easier when ur looking to take out the screw that holds the rotor in place.

1. Dont break it thats being a butcher.

2. You can turn the crank if u like getting dirty.

* wanna make life easy after u take out the cap and all your wires. Just touch the key until the screw gets in a position where u can reach. You can leave ur plugs in.

Dont worry u wont get shocked, just remember to disconnect battery for all that other stuff.

You can even do the fuel filter while your there its easy

imported_chris_v2

Or you can just turn the powersteering pump pulley.