Throw-out bearing in MT
01-Jun-2008, 06:35 PM
#1
Junior Member
Thread Starter
Join Date: Mar 2008
Posts: 2
Throw-out bearing in MT
Hi Everyone.
I had my clutch replaced about 20 000km ago. Now my throw out bearing are going. You can hear a clicking noise when the clutch is out. I drive in stop and go traffic for work, 140 km a day both ways. Any ideas on what I can do besides getting a new transmission?
If I need to get a new MT, where is good place in the Hamilton-Oakville area. Also a engine if I am going to be replacing everything might as well do it at onces.
I had my clutch replaced about 20 000km ago. Now my throw out bearing are going. You can hear a clicking noise when the clutch is out. I drive in stop and go traffic for work, 140 km a day both ways. Any ideas on what I can do besides getting a new transmission?
If I need to get a new MT, where is good place in the Hamilton-Oakville area. Also a engine if I am going to be replacing everything might as well do it at onces.
Last edited by Fluke02; 01-Jun-2008 at 06:43 PM. Reason: Wrong Thread
22-Jun-2008, 08:34 PM
#3
Senior Member
Join Date: Sep 2007
Location: Pfaff
Posts: 1,560
your throw out bearing was replaced when you did your clutch. If the shop didnt change it, I'd be really surprised.
You most likely have an input shaft bearing problem.
How loud is the noise? If its barely noticeable, just leave it.. they all make noise, the cost to fix it is very expensive in labour
You most likely have an input shaft bearing problem.
How loud is the noise? If its barely noticeable, just leave it.. they all make noise, the cost to fix it is very expensive in labour
Thread
Thread Starter
Forum
Replies
Last Post
besusprice
Honda Civic Performance - JDM Discussion
4
28-Dec-2007 05:19 PM
imported_CRXXX
Honda Civic Performance - JDM Discussion
2
19-Jun-2007 05:35 PM
imported_2drcivic
Honda Civic Performance - JDM Discussion
21
13-May-2007 09:35 PM
