mquan4165

hey i have these eurolite reverse light gauges that use to work just fine. But one day they just started cutting in and out and eventually just stopped working. Ive checked the wiring, and its all connected properly. There are no loose connections. Does anyone have any suggestions, Im thinking the transformer has a problem but im no good with that type of stuff.

stev

iTrader: (1)

do they have bulbs? are you able to check them? #basicbellcsrtroubleshooting

mquan4165

no theres no bulbs...they are your spedometer, gas, battery, engine temp gauges. they are flat face plates that replace your regular looking gauges.

F8i

iTrader: (10)

Try rewiring it, checking grounds, use solder if you wired them.
(you said you did all that) Look for corrotion(sp?)

Finally, measure voltages. All I can suggest atm.
-B

iTaLiAn_vIrUs

do what F8i is telling you..

also research that gauge. maybe other people have experienced the same thing?

rick10

are these the gauge?? oe something like this




There isnt much you can do , just check power and ground. Mine actually went out one day and came back after two days , and i didnt even do anything , it just came back one day

you could also remove the cluster to make sure the power or ground wire got cut. I know i had a hard time closing the plastic cover for my cluster with the power and ground wire in the way. I actually had to force the plastic cover on top of the wires , so sooner or later it may get cut...

joenow

thanks for the info guys..really great

iTaLiAn_vIrUs

did u fix the issue?