Skunk2 Intake mani with AEM fuel rail
 

So i had bought a d series intake manifold a while back and i just picked myself up an AEM fuel rail for my d16y8.

My question is the skunk2 intake manifold has 3 studs coming off to give the fuel rail something to mount too. But the Fuel rail is meant for a d16y8 and has 2 offset holes for mounting instead of 3 evenly spaced. I am seeing if anyone has had this problem or knows any ways about fixing it.

My idea for now is getting a piece of flat bar and drilling 3 holes for it to fit on the manifold, then drilling to offset holes for the fuel rail to attach to. Basically making a bracket to sit in the middle of the mess.

So this is what i ended up doing, Everything is tight and sealed from what i can tell. Any questions feel free to ask.


http://img33.imageshack.us/img33/4815/imgp2570.jpg

good stuff,

so if i understand this right, the fuel rail you bought was not for Y8? but you modified to make it fit

nope AEM has it right, it was meant to fit the y8 manifold not the skunk 2 manifold. For some reason the skunk 2 manifolds just make 3 even mounting screws, or the one i have did anyways. The y8's only have 2 mounting screws