zc bounces
#1
zc bounces
i was just gunning my way home on steels......and i have an automatic zc, and i was gunning the car from about leslie and 16 on to the highway and on to steels and right down to warden and steels....only sometimes when i hit close to 7 k, it hesitated....
and i tried it a few more times and it was fine, then it started hesitating....it was running fine before, but i noticed that in my previous motor, this happened when i was low on gas, and i checked the gas tank a second ago and i am well below the redline.......do u think this can be the problem? and is that bad?
and i tried it a few more times and it was fine, then it started hesitating....it was running fine before, but i noticed that in my previous motor, this happened when i was low on gas, and i checked the gas tank a second ago and i am well below the redline.......do u think this can be the problem? and is that bad?
#6
tend to agree with dave....si rev limiter is around 6500....if you have the ZC ECU then your rev limit is about 7200 - 7500...again sounds like you hit the cap.
Bring it to KS-R if you are really worried...he's a wiz with the ZC engines....he's a TCC affiliate
Bring it to KS-R if you are really worried...he's a wiz with the ZC engines....he's a TCC affiliate
#8
wussies huh....well i wanted stick.....but thats just the way the car was givin to me...plus, its expensive to make it stick......maby i'll work on that later , when i make some money..........
#13
Originally posted by jon loback
.... are you guy's saying that you can convert a auto to a standard and not spend a arm and a leg? how much money are you talking bout to get that done?
.... are you guy's saying that you can convert a auto to a standard and not spend a arm and a leg? how much money are you talking bout to get that done?
Less than $2000...
Maybe less if you smile pretty....
#14
there was a guy who came to your meets in summer, hwo does the work himself, and he told me that he usually sells the auto trannys for more, and buys 5 speed tranny's with money to spare.....and he claimed to do it under 600 with installation..
#20
i vouch for KS-R's quality and service.
-> lol, that happened to me once, i couln't put the gas all the way to the floor because the bloody map crimppled up behind the pedel. didn't even know, i thought my throtle cable became loose again. hehe, fooled me.
-> lol, that happened to me once, i couln't put the gas all the way to the floor because the bloody map crimppled up behind the pedel. didn't even know, i thought my throtle cable became loose again. hehe, fooled me.
Thread
Thread Starter
Forum
Replies
Last Post