What wires to tap in to on O2 sensor for Air/Fuel Gauge 3 wires
#1
What wires to tap in to on O2 sensor for Air/Fuel Gauge 3 wires
I have a jdm b16a2 and am installing an air/fuel gauge and need to know which wires to splice to connect.
thanks in advance
thanks in advance
#2
the signal wire coming from the sensor. I think in my case it was white... but that may not be the case for you. Take a look, the wires are in plain sight if you'd just pop your hood.
or, if you went to autometer.com you would find a full set of install manuals. is that too much work for you?
or, if you went to autometer.com you would find a full set of install manuals. is that too much work for you?
#3
honestly man, i searched autometer and didnt find anything so i turned here thinking others have done such and have knowledge of such....no need to be a ***** with your comments....thanks for the help....no thanks for the sarcasum and smart *** remarks.
#5
you should splice into your ecu harness near your ecu and find out which pin out on the ecu is the o2 wire it will give a better reading then straight off the o2 sensor but the easy way is to splice into the white wire, i have the same motor and i did that but it reads better at the ecu.
Thread
Thread Starter
Forum
Replies
Last Post
SickoTeg
Honda Civic (+ other) Parts/Accessories for Sale or Trade
4
05-Jun-2006 05:50 PM
imported_Turbo-D
Honda Civic Performance - JDM Discussion
6
07-Jul-2004 08:09 PM
johnny23toronto
Honda Civic Performance - JDM Discussion
4
10-Mar-2003 11:36 AM