SirPhil

i was crusing and i went from 2nd to 3rd and it was jus stuck in 2nd. i put it up to 1st gear and its still in 2nd. when its in the neautral position its still in gear

if u have an idea or know wat is wrong please let me know,


its a 2000 sir



please pm back

imported_ERTW

lets hope its something with your shift linkage and not internal transmision damage. could be the shift linkage pin.

when your car is off, and you shift, do you hear noise coming from your transmision? if you dont, its something with your shift linkage

imported_kIeRaN

yeah, id guess its something to do with the shift linkage, take out your shift linkage or take a look at it from underneith, could be a bad bushing in the linkage

bbarbulo

iTrader: (2)

has anything been done on the car recently, like a short shifter or clutch or something?

imported_Cablerat

Sounds like Linkage is disconnected somewhere.. does the shifter feel really loose when you move it around?

bbarbulo

iTrader: (2)

I think the internals are fuct somewhere... if it was linkage, it would be dragging on the ground

imported_Cablerat

yeah i guess eh.. didn't think about that..

Maybe is broke @ the shifter.. isn't one of the rods welded to the other? But then again, if one broke he would still be able to find another gear.

4_door_teg

Like everyone esle said, Shift Linkage. It happened to me in my old car.

bbarbulo

iTrader: (2)

I was halfway joking

imported_loudsubz

maybe the bitch pin came off where the linkage attaches to the tranny

imported_gatherer

I'm a beating on a bust tranny.. I've seen this 4 times before...