this transmission swap I did
 

ok as some of you know I did a transmission swap on saturday (or completed it then after 12 hours of work)

so 22 hours to remove the old transmission and place a new one in..(no excuses here 1 I should have had the car higher so that I'd fit under on my rolling lie on thingy would have made it a billion times faster....and 2 I work slowly)

now I have an issue I need help with...

my reverse lights don't work... I figure it's the sensor.. now since the transmissions are the same can I remove the old sensor in the old transmission and place it in the new transmission? or do I need to get a brand spanking new sensor?

just replace it

or check to see if the harness is messed up or not connected 100%

Just swap the sensor over if the one on the old tranny is still good (that's if the tranny you put in is the same, eg 5th gen stock tranny)

ok cool just wanted to make sure by removing the good sensor there's nothing thats delicate on the sensor that I could distory by removing it.... thanks guys..