imported_JDM_Outlaw

Hi there...

I just acquired, Koni Yellow shocks and H&R Sport springs

from a 00 GSR...

my car is a 98 Civic Coupe which is right now waiting on to get onto the road...

so far I got the front shocks and springs

installed without a hitch..

but I remember reading from this board that there is a way to install the rear shocks from an integra into a 96-00 EK chassis using spacers...

now which spacers are we talking about, more like washers?

if its washers how many do I use?

but are there any other type of spacers that anyone here can recommend?

thanks for your help

imported_slowandfurious

The washers are used on the rear shocks so the lower mounts dont get pinched closer together, when putting the bolt threw it. EG and DC tegs use a slightly wider bushing than ek. So the washers are used to take up space, and the lower fork doesnt get squeezed closer together.

Nova_Dust

Get the washers from H-D or Rona.

imported_JDM_Outlaw

alrighty....Instead of Home deport or Rona..

go gonna a little bit overkill since its on the way to work..

Off to Brafasco...going to get a higher grade bolt and washer

yet those who have done this, do you use a lot of washer or maybe very little, like two or three?