Someone With OBD-0 to OBD-1 Harness, Please help me...
 

I have just recently Purchase a harness from rywire.com for the 90-91 SI OBD-0 to OBD-1 for the B16...

I need to know if someone has the same type of harness i dont care if it is from rywire.com as long as its obd0 to obd1.

Im wondering if your car is working off this setup can you tell me where you purchased the harness from?
and
would you be able to come over and lend me the harness for a few seconds just so i can see if when i put the key to the on position, if my fuel pump turns on or not.......


HERE IS THE PROBLEM THAT IS GIVING ME SO MUCH AGRIVATIONS

Now when i hooked everything up the car would crank over but the fuel pump would not work, not even when i turn it to the on position (when the fuel pump primes the cylander)

now i have found another problem

one of the main 12V feeds from the engine bay fuze panel goes to the jumper harness on the main ecu is getting is required 12V, but when i disconnect the B harness i am getting 12V out of the ECU on the same pin,
so if i am putting 12Vin and i am getting 12V out of the same pin something has to be F&*KED up of my jumper harness...


If you can solve my problem it would be much appreciated if you do have the time and are able to drop by and lend me the conversion harness for 5minutes that would be even greater..

please get back to me at
michaellaw_17@hotmail.com (That is also my msn sign in name)
or
mugencivicsi@rogers.com (this is my main email)


thank you for atleast taking the time to read my story, you dont understand how frustrated i am right now......



thanks for looking
Michael