imported_Slvr-Bullet

Swapped in my OEM wires and forgot which order they went in.


Does this seem right??

bbarbulo

iTrader: (2)

if your car runs it's right It won't fire up if it's not right.

YES, that IS correct, but I like to route #1 at the top of the wire-holder thingy... much cleaner.

imported_gatherer

not sure anyone know the firing order ???

from what I see there you have 1 3 4 2

I think it's suppose to be 1 4 2 3 (but I could be wrong my car is in the shop so I can't just go outside ajnd look

punkindrublic

actually according to my manual the wires should be like this

--3
2 + 4
--1


as if your looking at the distributor as in your second pic

imported_Slvr-Bullet

Well since your car is a '93 and mine's a '96 I think there's a difference.

I wasn't sure if that was the correct order, eventho I have a service manual , becuase the wire length just didn't seem right.

The #1 wire just barely makes it to the dizzy location.

*edit* Man!! my valve cover looks nice in that pic

punkindrublic

oh you could be right about the year difference... i thought the same thing when i used my set up for wires the first time.... cause the no 1 wire barely made it

bbarbulo

iTrader: (2)

Ya, but your engine is SOOOO dirty

What, no one trust me when I say that it's correct??? I'm offended It runs, right Steve? It wouldn't otherwise. Plus, I know that's the right order. Those two put together... what more can you ask for

imported_eth0r

wtf, whats that slightly hidden by the intake manifold??????????

punkindrublic

its not that i didn't trust you... its just the wiring order for my motor is different and i had my book sitting beside me so i looked

imported_SW20 MR2

I may be wrong, but the correct numbers are right on the dizzy cap. You can even partially see them on the pic.

bbarbulo

iTrader: (2)

automatic belt driven pencil shapener...

Kevin, you are correct....

Steve, reason it doesn't reach correctly is cuz you got them routed wrong.

imported_eth0r

imported_Slvr-Bullet

All it says is "A" (close to #4) and "C" (close to #1) on the cap, unless you're referring to the wires.

imported_Slvr-Bullet

Who looks at an engine bay anyways. It's what the outside looks like that counts

Haven't tried firing it up yet.

bbarbulo

iTrader: (2)

Bah, I'm sure it's fine...

imported_Slvr-Bullet

Ok Mr. B

*edit* There is that better

bbarbulo

iTrader: (2)

bbarbulo works... or Bruno, whatever