imported_torscot

hey, so i got my c-pillar bar and rear strut bar, c pillar went on no prob, but i thought upon guttin my back seats i could see the strut towers to mount the bar. however i dont, i take it i have to cut a hole in my plastic interior? is there an easier way of doing this without cutting? or do i just gut everything? and if i resort to cuttin, where the hell is it?

imported_Kingjames1983

there is a thread exactly the same as this on here... not sure where it is!
You either cut holes (please search to do it right) or remove the panels and leave them off which to most look uglier than a hilton sister.

imported_gotti78

Lucky when I did mine one side was already cracked open from when my car was stolen so I only had to cut a hole on one side. It was super easy to do, making it look clean is a diff story, I cut the hole a lil too big, but I figured it was already mesed up anyways!