Question on CEL
So Was drivin this morning and to my surprise! The number one thing i hate to see! The CEL is on. Jumped my Srvc Connector and threw these codes
6Short(Code 6) Long pause This is supposed to be the ECT Sensor 8Short(Code 8) Long Pause This is supposed to be TDC Sensor 4Long,1 Short(Code 41) This is suppose to be Oxygen Sensor / Heater Circut Repeat Anyways i figured since the new suspension upgrades and bumpy roads i could have loosened some of these sensors. I unpluged the Harness on the Dizzy ( the big harness ) to check for any bent plugs or dirt. Thing was fine? Then checked the ECT Harness to see if it was loose... it was fine as well? I basically made sure all those connections were snug. So i reset my ECU ALL Codes are gone?! Wtf? Even with these codes the car still ran prime.. any ideas on what caused this? Im stumped?! As for code 41 im was assuming im gonna change my o2 sensor before i start tackling plugs, wires, filters etc.... but the code is no longer there. |
tdc sensor, is in your distributor.
o2 sensor has failed obviously. If you have a solid street tune you can run open loop and disable the heater circuit. check the wiring to the ECT, if fine, replace it to. a bad ect will affect your performance greatly |
im on hondatas100
honestly i noticed NO preformance change whatsoever. how you been btw posposchris? |
or you could put a piece of electrical tape over the light like homer simpson, and not worry about it! :P
|
Originally posted by Nicotine or you could put a piece of electrical tape over the light like homer simpson, and not worry about it! :P i've been good bryce.. |
yeah soo... turns out my alternator was on its way out.. sent all sorts of electrical **** on the fritz... i have no cels after the new alt. was installed.
|
All times are GMT -4. The time now is 06:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands