port and polish IM and TB....where?
Where can i port and polish IM and TB for a car, preferably RACE port and polish...
somewhere relatively cheap |
You could try Defcon. Gord Bush Performance is another one that I would visit, also Canadian Cylinder Head.
Altech, too. |
how much would that usually cost.........???????
|
maxxbore.com
|
TB bore is not whole lot, but if you want to open up the IM, that could be costly. As to how much, I haven't done that before so cannot give you a price range.
Best is to call these shops and tell them what you want. |
where can u get a race port and polish for cheap? Gord Bush is the only machinist in the city that i'd advise. but, what other mods are done to the motor? are u sure this what u want ur next mod to be? there is very little gain available with stock cams, compression and ecu. which im do u want ported?
|
cheap = not a good job
u have to pay someone to do it right...they charge a few hundred dollars for just one piece of TB or u can port it by urself...that would be the cheapest way to go...only if u can spend 5-6 hrs on the job |
for a good port and polish its 1000+
|
Originally posted by m power where can u get a race port and polish for cheap? Gord Bush is the only machinist in the city that i'd advise. but, what other mods are done to the motor? are u sure this what u want ur next mod to be? there is very little gain available with stock cams, compression and ecu. which im do u want ported? its good to answer m power's questions before deciding to do anything. No point in P&P if your setup doesn't need it. |
All times are GMT -4. The time now is 09:36 PM. |
© 2024 MH Sub I, LLC dba Internet Brands