please help need info
#1
please help need info
hey guys i have a b16a, planning to put a gsr hydo tranny to it. i did not get a wiring harness with the motor. The question is would i be able to use my factory acura el harness with the motor which has is vtec? Or will i have to go for a b16a harness. Also what about using a gsr harness with a obd2 computer? Anythought of what i should use? please pm me or wright me back, i really dont know what to do
thanx
thanx
#3
Punk did you read the post he's asking about wiring harnesses...
Slow and Furious,
the b16a is it OBD2? if not you will have to either A) convert the engine to ODB2 (could be hard to do) or B) convert the ECU wiring and Harness to the OBD level of the Engine (easier but you will need a wiring harness
Slow and Furious,
the b16a is it OBD2? if not you will have to either A) convert the engine to ODB2 (could be hard to do) or B) convert the ECU wiring and Harness to the OBD level of the Engine (easier but you will need a wiring harness
#4
thanx everyone for there info.
So i can stick with the harness already inside my car? the motor i believe is obd1
Also about the tranny, should i go with the gsr or should i look for an sir hydro?
So i can stick with the harness already inside my car? the motor i believe is obd1
Also about the tranny, should i go with the gsr or should i look for an sir hydro?
#5
if the motor is OBD1 then you have to convert the car to OBD1 you might be able to get away with using the OBD2 wiring harness and leaving the plugs disconnected that don't have sensors however, AFAIK the plugs are different between the 2 generations...
Thread
Thread Starter
Forum
Replies
Last Post
artie93
Custom Honda Civic Exterior - Lighting
13
02-Jan-2008 07:25 PM
1ofAkind
Honda Civic Performance - JDM Discussion
2
10-May-2006 12:03 PM
civic_integra
Interior - Audio - Security
11
01-Aug-2005 12:53 PM
imported_WEBSTER
CFz Discussion
33
12-Jun-2004 09:57 PM
imported_Half_Baked
Honda Civic Performance - JDM Discussion
4
16-Apr-2003 05:33 PM