please explain and help.. ty
#1
please explain and help.. ty
--------------------------------------------------------------------------------
the picture below is for koni installation. please explain the diagram 1,2,and 3.
i can adjust the height by doing that? cause my driver side is 1/3 of an inch lower than my passenger.
http://img.photobucket.com/albums/v4...r/IMG_0144.jpg
----
i just picked up a omni camber kit. guess what kinda of material the flat washer is made of.. ALUMINUM..
after i put a rough surface washer (the one that with "jaws") and tighten it with a little force then it made dents on the surface of the washer. should i just use it as it is or should i replace the washers with steel washers?
http://img.photobucket.com/albums/v4...r/IMG_0115.jpg
the picture below is for koni installation. please explain the diagram 1,2,and 3.
i can adjust the height by doing that? cause my driver side is 1/3 of an inch lower than my passenger.
http://img.photobucket.com/albums/v4...r/IMG_0144.jpg
----
i just picked up a omni camber kit. guess what kinda of material the flat washer is made of.. ALUMINUM..
after i put a rough surface washer (the one that with "jaws") and tighten it with a little force then it made dents on the surface of the washer. should i just use it as it is or should i replace the washers with steel washers?
http://img.photobucket.com/albums/v4...r/IMG_0115.jpg
#4
The driver's side is usually lower then the pass just because that side of the car is heavier. I can't see the pics either, but the Koni Yellows and the Reds are height adjustable by moving the spring perches up/down before the springs are installed.
#9
My car used to lowered on H&R springs only. It raised up when I put on Reds and an Eibach camber kit (adjustable ball joint) It used to tuck in the front, but now you can can one finger in there. I think it's the camber kit.
#12
koni sport(yellow), it have 3 perches. i set it at the middle.
distance between each perch is 1/2 inch. if i increase the lower side by 1 perch, the lower side will be higher than the other side.
here is what my car looks like now.
http://img.photobucket.com/albums/v484/integra-r/IMG_0107.jpg
http://img.photobucket.com/albums/v484/integra-r/IMG_0106.jpg
is there any other way to fix this? or should i just get a set of the ground control sleeve for it.
distance between each perch is 1/2 inch. if i increase the lower side by 1 perch, the lower side will be higher than the other side.
here is what my car looks like now.
http://img.photobucket.com/albums/v484/integra-r/IMG_0107.jpg
http://img.photobucket.com/albums/v484/integra-r/IMG_0106.jpg
is there any other way to fix this? or should i just get a set of the ground control sleeve for it.
Thread
Thread Starter
Forum
Replies
Last Post
civic_integra
Interior - Audio - Security
11
01-Aug-2005 12:53 PM
imported_DesiSpeed
Honda Civic Performance - JDM Discussion
13
13-Jun-2002 11:23 AM