motor wont start
 

ok so i finally put in my z6 and wired everythings up its just on headers right now its not connected to the exhasut .anyways heres my problem.i dont have the thottle cable or clutch cylinder attached right now because i didnt have time but i got someone to open the throttle a little bit and it cranks and turns over but it sounds like a go kart and it smokes really bad.right now i have dsm 450's in there (yes those are probably the reason ill take them out tommorow)is that a reason why its running like ****.also when i let off the throttle the car just dies???? any suggestions

why are you running 450 cc dsm injectors ? if your using them for turbo you need something to control them (chipped ecu apexi afc ect)they wont run on a stock ecu. put your stock injectors back in and you should be good to go!~

because when i built the motor like clutch and all that i thought i was going to install the turbo with the motor but things came up and im going to run the stock motor for like a week so i was lazy and didnt want to take them out for the start up .is that a reason why when i let off the gas they die though???

yes it is.

450's on a stock motor, with a virgin p28.

:tsk:

ya i took them out and it fired right up with stock injectors but i ran it for like 3 minutes and the car just died and the spark plugs were like jet black and i did **** around with the dizzy b4 so im guessing the ignition timing is WAY off???