looking for opinion on topic inside thread?
28-Aug-2003, 01:48 PM
#1
Senior Member
Thread Starter
Join Date: May 2003
Posts: 2,265
looking for opinion on topic inside thread?
If I have the meens of dynoing anybodys car with full print outs and suggestions on some tuning to inprove performance and was capible of full sensor print outs from engine readouts would you guys and girls pay $100 to have this done? The only thing is that the cars have to be 96 and up due to the fact I am pluging the dyno computer into the ODB II port in the car. 96 and down use the ODB I port from what I have been told.
So just wondering so please be hounest and give me you opinoin
in the thread or pm me, but most likely I will be performing this service in about 1-2 weeks.
Thanks for your support.
So just wondering so please be hounest and give me you opinoin
in the thread or pm me, but most likely I will be performing this service in about 1-2 weeks.
Thanks for your support.
28-Aug-2003, 02:11 PM
#2
in reality, this is good, but for $100 you can get your own OBD2 scanner and software for real-time sensor read outs, and if you know how to use that info, it's that much better...
so unless you got a wideband O2, there is really nothing new that you could tell us.
Of course there are others who may benefit from your service, lord knows not everyone knows how to make use of key information.
so unless you got a wideband O2, there is really nothing new that you could tell us.
Of course there are others who may benefit from your service, lord knows not everyone knows how to make use of key information.
28-Aug-2003, 02:18 PM
#3
Senior Member
Thread Starter
Join Date: May 2003
Posts: 2,265
this is exactly what i can do for anyone who wants it done
Generic OBD II Engine and Vehicle Information
Diagnostic Trouble Codes (DTC)
Displays real-time sensor data. Up to two sensors can be monitored and graphed simultaneously
Up to 5 sensors can be displayed in bar-graph and analog
Display following sensor types:
Load Value - Vehicle Speed - Coolant Temperature - Ignition Timing Engine RPM - Fuel Trim - Mass Air Flow - Intake Air Temperature Throttle Position - Fuel Pressure - Intake Manifold Pressure Oxygen Sensors.
Generic OBD II Engine and Vehicle Information
Diagnostic Trouble Codes (DTC)
Displays real-time sensor data. Up to two sensors can be monitored and graphed simultaneously
Up to 5 sensors can be displayed in bar-graph and analog
Display following sensor types:
Load Value - Vehicle Speed - Coolant Temperature - Ignition Timing Engine RPM - Fuel Trim - Mass Air Flow - Intake Air Temperature Throttle Position - Fuel Pressure - Intake Manifold Pressure Oxygen Sensors.
28-Aug-2003, 03:03 PM
#4
Senior Member
Join Date: Apr 2002
Posts: 12,906
i have a 5th gen so it wouldn't help me out... however if i got a new motor i think i would pay $50 to just dyno my car for bragging rights if nothing else.... i dont know where it was but someone i used to work with could get me a few dyno pulls with print out for $50....
Thread
Thread Starter
Forum
Replies
Last Post
