Koni Red owners, a question for you...
 

Okay I have a set of Koni Reds already installed on my car....

and I already know that you can set the height either at stock or a bit lower....

question is though......I am set too the lowest cause I fliped the cup...

but like I did last time, when re-fliped the car to as it says its normal position, my car sat way higher than stock.....

so my question is how do you set the height on the Koni Reds? any tips or tricks yall can share?

I have the Reds, but I'm not too familiar with the "flipping the cup" you speak of. The Reds have the small C-clips that can be moved up/down to adjust the height a bit. What kind of springs do you have? It might also take a few days for evrything to settle again.

I have Esplier Springs for 3 years, owned the koni Reds for 1.5 years.

the drop is supposed to be 2 inches....

but as it stands, it looks like a slammed 2.5 front and rear...

the car is being sold soon, so I juss figured to raise it up, cause this would be the owners frist lowered car and was scared of driving at the height it was....so seeing how i remember something about the perch was set, I wanted to see if can be raised up a bit

I'm also selling my car, but I'm putting the stock parts back on. I might give any buyer the option of taking the Konis if they want. I think a stock car would sell easier then a modified one. Even moving the perch will only change the height by .5" at most.