imported_doggy69247

Wel it started of ****ty had 2 drive 2 ****ing grimsby who the **** livs all the way out there hour and a half drive and dident have a clue were i was going

so got them from 1PhatCX nice guy and i get thome and try 2 get the old ones off and i mannaged 2 snap the head off the bolt holding the lower y arm of the strut off so im like ok il just drill it out i will take the entire arm off and then i snapped the ****ing bolt off in the back bushing so i get my sawzall and set off cutting through the bolt and my blade went dull in like 1 min


****ing cheep dewalt blades o well


so no more blades i have 2 grind it off so i do that and then 5 drilbits later i managed 2 snap a drilbit off in the ****ing bolt so now i have a hardened bolt and a nice anf hard drilbit in there AAGGGHHH

so off i go 2 crappy tire walking cus i have no car now i go buy some nice new masenry drillbits and go 2 my dads place he has a drillpress and i finaly after lots of smoke and hastle get them out and the pasanger side toom e 7 mins old 1 out new 1 in it was wicked i hope the front is as easy ands the pasangers side

looks soo much better now lowered hahaha but looks funny i only had time 2 do the back so looks like i have 4 boddies in my trunk ahhaah front sticking up in tha air i bet i take off with all the ****ing wind rezistance il take pix tomorow its 2 dark

imported_doggy69247

what is my best thing 2 do here get some like aftermarket arm or just go get all the ****ty origonal bushings pushed out and new ones put in ??


went 2 nappa they dont have any and grappy tire they are discontinued there

imported_Team Rukus

aftermarket will be cheaper then brand new.

kwasley

my rear bushings all had to be torched out so instead of buying 6 new bushings at 20-25$ a peice, i got new lcas with preset bushings.

imported_doggy69247

ok thanks and i can get them from any performance shop ?

and how muck am i looking at here??$$$$$

imported_Team Rukus

i think optionjdm carries the omni power ones for ef.
looking prolly around 200 or something like that for a pair of lca's with pre pressed bushings.