92JDMx

Well i hit a problem, finishin up...
i have rc 440cc injectors, and they do not fit properly in, i use the greenish bushing i guess that come with them, but it seems to be a really really tight fit... any suggestions on installing these.

zeeman

iTrader: (1)

where are they not fitting....the fuel rail? or the manifold?
If its the manifold, you might need to dremel out the hole in the grommet a little bit.

92JDMx

ya they are not fitting in to the manifold, so dremel out manifold a bit? lol i have been loaftin on this, as u can see andrew, sooon it will be done

imported_italstallion

noooo do not dremel the manifold dremel out the o-ring that sits in the manifold

zeeman

iTrader: (1)

exactly, DO NOT dremel out the manifold....enlarge the hole in the o-ring that sits in the manifold. This will allow the larger injector to fit into the o-ring.

turbo___zc1

http://www.homemadeturbo.com/tech_pr...dsm_injectors/
this should help

92JDMx

no no the o-ring, fits around the injector perfectly, its just that putting them in the manifold after is very tight

imported_italstallion

well it should be very tight but if its too tight that u cant fit the injectors in take a dremel with the bit that has a sandpaper roll around out and shave it down a little bit.

chris_si98

putting them in the manifold is tight? so it fits, just tight? Thats fine.. lube up the outside a LITTLE bit.. and tighten the fuel rail on top of them and see if they stay in place. If not just take a tad off the outside of the o-ring with whatever you have handy

92JDMx

ya i m going to shave a little off the outside of the o-rings, i was just wondering if there was a special technique or if i was missing something.. thanks everyone

imported_italstallion

just make sure u go ina circular fashion dont dremel a big indent in one part of the ring and do it little at a time.you can always take more off but you can never add more.