imported_crx__4u2nv

I just got a turbo out of a talon first generation (t3)I think? anyways i also got the injectors (450cc) are theses anygood? and what eles do i need to set this up in my DOHC ZC CRX ?? what ECU chip do i need? and what eles will i need for this set up??
thanks Robbie

4_door_teg

http://www.cse.uconn.edu/~yelevich/turbo/turbo.html
www.homemadeturbo.com

start reading. You'll need a manifold, piping, bov, intercooler, oilfeed, fuel management, eninge man., plus more. those 2 sites are a good start though.

imported_Torrey

1st gen talon is a 14b

bbarbulo

iTrader: (2)

talon turbo is a Mitsubishi unit... good choice. cherry turbos rebuilds them in Ontario... great guy!

red90dx

CRX_4u2nv, you need to do more research, you have some parts, great but hooking everything up PROPERLY, and tuning it so it doesnt grenade on you is another..

the first gen talon turbo is a 14b mitsu turbo, td05, <---only if it came from a manual car, same with the injectors, blue top 450's

the automatic talons had 390cc injectors and a smaller turbo, td04, so I need some more info.

as far as ecu, have it chipped, and use a custom tune of Turboedit, this software is GREAT!, you need a turbo manifold, wastegate, bov, intercooler, charge pipes, etc....

hope this opens a new page for ya.

B18C|

and start running ultra 94 gas with a turbo motor to maximize the full potential of the car otherwise ull run like crap and have retard timing like a mfo...

the 14b maxes out at 6000 rpm it doesnt make anymore power after that, it will just be blowin hot air so if your planning to rev high 8 or 9k rethink your plan for a different turbo.

imported_crx__4u2nv

see iam just really looking for off the line like first 2 or 3 gears so it should work good rite?

red90dx

it will be fine, 14b is fine for a zc, remember the redline is 7200, most only rev to 6800 or so on zc, the power is dead by 6700 or so.