neilff

people with the b16 2nd gen jdm engines, how much was the total on getting your engine installed?

mines burning oil, but so far, ive driven it with hardly any problems. im thinking, if i hold out, maybe i can purchase a b series depending on price.....

i need to know everythingggg!
im riding in a d16z6 hooked into a 92 civic si hb
what do i need to change out other than the motor?

OverKill

Get it done at Altech...

Not sure what Joe's current prices are but they are one of the most reasonible not to mention their installs are cleaaaaaaaan!

Happy??? (Formerly HappyB16) and myself both had our Civics (hatchbacks) done there.

What do you need? Engine, Tranny and ECU of you're going for JDM B series motors. I wouldn't "hold out" too long because....

A) it'll go on you when you least expect it and leave you stuck somewhere.

B) The longer you hold out, the more rare JDM B16's will be. The more rare, the more expensive.

Regards,
OK

neilff

nothing different for fuel management? cooling system?
also, i dont need mounts right? cause its direct swap..?

Import Racer

I got mine done there too about 3 years ago.

Import Racer

Other than the motor, tranny, clutch and ecu, you'll need shift linkage, motor mounts and drive shaft from an Integra. Can't think of anything else off the top of my head. Everyone, please feel free to add anything that I haven't mentioned.

OverKill

If its a JDM B16A2 it will drop right into a 5th gen hatch back without mounts and the shafts should come with the install at Altech.

As for a shift linkage, its not crucial but its recommended.. Try and get a Type R linkage and you'll be good to go.

Regards,
OK

ryuujin

dun u be needing drive axles as well?

Type R or GSR shift linkage would be fine

dingus8

I believe you need the sir rear mount.....but then there are hidden cost's ie. timing belt, water pump <---manditory I feel... then clutch, adn possibly oil pan gasket valve cover gasket and head gasket...