civicdx

hey, over the past few days ive been working on my obd0-obd1 conversion harness, i started out buy taking out the plugs of a pm5 ecu. Then I simply soldered wires to the end of each pin. Im going to make a write up on how to do this when im done, heres a few pics (im sorry if the links dont work its my first time posting up pics)

http://i41.photobucket.com/albums/e2...Picture089.jpg

http://photobucket.com/albums/e297/c...Picture090.jpg

imported_sleepgsr

keep up the good work

Capo

all those exposed pins look like a short waiting to happen.....

LEITNER

your heat shrink should be butt up against the connector...but its nice to see someone using their heads and a little enginuity. when you are done and if it works that would be a great sticky for the board.

civicnation

i'd get some heat shrink and put it right up against the connector so that you are not risking anything shorting. other then that, it is some damn nice work.

LEITNER

did you just copy what i said? post ***** is correct...lol

civicnation

lol, i didnt even read what you wrote. that's what i get for not reading all the replies, lol

imported_hdave

lol, i bet he didnt even read what you write. that he gets for not reading all the replies, lol

imported_hdave

pardon the fact that english skills are suck

imported_hdave

aw **** it happened again.

sorry about my bad english, and yes sorry for post whroring like civicnation

(btw i double checked this post)

civicdx

thanks guys, a couple of days ago i went over all the connections with a glue gun to insulate all the exposed pins and it also seems alot stronger. hopefully the weather gets better so i can go to the junk yard and get some plugs.. thanks for the feedback