Engine swap = speedometer stopped working
went from D15 to JDM SI 1.6 and speedometer stopped working..
anyone got a clue? its a 2nd gen crx |
check the cable in the tranny
|
you notice a big difference the Bentley is a heavy car
|
im not very car literate, where is the cable in the tranny
|
VS sensor, its a sensor located on top the tranny, 2 bolts and a plug and shell come rite out. Find a buddy with a civic and swap with his to make sure that thats the problem and if it is, buy my extra vs sensor :)
|
ummm looked up VS sensor on google and got no real results
|
Originally posted by v8hunter03 you notice a big difference the Bentley is a heavy car |
Originally posted by Azoogle ummm looked up VS sensor on google and got no real results |
Did they swap your tranny too? Some of the JDM trannies have electric VSS's, and the North American cars have Cable VSS's in the 2g CRX's.
If they didn't swap the tranny, you probably just have the speedo cable unplugged from the tranny. |
i still have same tranny. so is this the vss or is just a cable? and where is the cable
|
Originally posted by CyniKal.Mindset what in the fvck are u talkin about??? |
and in the post its clearly said the swap was in a crx DAWG
|
You have a cable for your speedo.
Make sure it's properly in the tranny, and hasn't slipped out. It's located near the rear mount on the tranny. |
ok i will try to located that. thanks alot for a usefull reply.
|
Originally posted by v8hunter03 you notice a big difference the Bentley is a heavy car |
ok i know im a retard but is there anyway any of u guys can maybe show me a pic of what to look for and where
if it helps the odometer isint working either |
and check engine light comes on
|
You have a CRX - do you know how to check the engine code?
Pull back the carpet in the passenger's side foot area. The computer is at the bottom of the firewall. There is a red light on the ECU that will blink. Short blinks are 1's and long blinks are 10's (so 2 long, 5 short would be 25). Code 17 (1 long, 7 short), is the code for the speedo. |
Okay.. You have a CABLE vss.
Did YOU do the swap or what? Look on the back of the tranny (on the top) its right beside the rear mount, you will have to remove air intake. Use a light. There will be a cable (bike cable) going into the top of a small looking tower thing on the tranny. It PLUGS in. The tower thing is held in by 1 bolt with a 10mm head. Get a long extension and remove it. Pull out the VSS (Might need some wiggling) then inspect the gear on the end, make sure its all there. Next pull the hood off your cluster. and you will see a cable going into the back of the cluster. Remove it (pulls out when clip is pressed) turn the speedo gear from the engine bay (on the end of the VSS (Veichle speedsensor) and see if the cable moves inside. It should... First of all.. make sure the VSS is even installed, it will be mechanical NOT electric. Goodluck. |
the swap was done by MJN Motors in Toronto
u know how u guys say the back of the tranny.........which part is the back?? |
All times are GMT -4. The time now is 05:57 AM. |
© 2024 MH Sub I, LLC dba Internet Brands