Engine Question
i have a b16, gen 2 in a 93 civic, what is involved to put it into a 98 hatch back, or coupe. Im just wondering what i need to do if anything, to get it in there properly. Any help would be appreciated.
|
rear tranny mount and drive side bracket from a 99-00 si-r. and all the b-series parts (axles, linkage, etc)
you'll also need a conversion harness to run a obd1 ecu |
How much am i looking at for all that
|
actually you need the rear tranny bracket (T-mount) from an SiR and the Post mount that bolts to the engine block from an SiR. If the car is originally manual then everything else is bolt up.
|
All mounts from 99-00 Honda Civic SiR (US Si)
Note: The transmission mounts are for the 99-00 SiR tranny. If someone could confirm that they would also fit the Integra transmissions it would make this thread more usefull! the T-Belt mount will fit any B Series engine however.) Timing Belt Mount Part # 11910-P30-000 (Mount bolts to the block underneath the timimg belt cover) Transmission Mount (top) **Update: All hydraulic trans use the same mount, therefore this mount is not required** Part # 50825-S04-000 Rear Mount (t-shaped bracket) Part # 50827-S04-N10 Torque Mounts left/right I don't have these part numbers. If anyone can contribute it would be appreciated. The transmission torque mount required will be for any Integra 94-up and Civic Si (Canadian SiR) 99-00. The A/C torque mount will be specific to the engine you have. All three mounts retail for about $200.00 CDN direct from Honda my mistake. |
Originally posted by chris_si98 Transmission Mount (top) **Update: All hydraulic trans use the same mount, therefore this mount is not required** Part # 50825-S04-000 |
so.. if you swap on obd1 tranny into an ek.. the ek mount won't work?
|
Originally posted by chris_si98 so.. if you swap on obd1 tranny into an ek.. the ek mount won't work? |
so how can z6 trannys bolt right up to EK chassis mounts?
|
Originally posted by chris_si98 so how can z6 trannys bolt right up to EK chassis mounts? here's a picture to illustrate it to you 1992-1995 Civic Upper Tranny Mount is #4 in the picture http://www.slhondaparts.com/images/PCI/13SR80/013/1.jpg 1996-2000 Civic Upper Tranny Mount is #6 in the picture http://www.slhondaparts.com/images/PCI/13S020/016/4.jpg :cake: For reference Paolo if your putting it into a 96-00 Civic with a MT already you only need #7 and the Mount in the bottom right corner listed as E-14-1. |
All times are GMT -4. The time now is 03:24 PM. |
© 2024 MH Sub I, LLC dba Internet Brands