ECU issues...Sir in an EK
 

hello there...I have recently put in an SIR motor in my 97 EK (si)...The question is...when I bolt in the ECU, two of the plugs work and the third clip is too small...I have looked on Honda tech, and have found some threads on it...however I am not a mechanic and still am unsure... I have also been told that there is a patch cord that is available to link the third wire in...does anyone know or can you help on this issue??? BTW, I have searched here and on honda tech...cant find anything that I understand...could someone put it in laymans terms for me...thanks


VIPER

u need a Obd2A-OBD2B harness

Adapter, or re-pin your ECU connector.

where would I get one of these??? any help is greatly appreciated!!! thanks

does anyone know where to get one of these adaptors...I have done searches on google and yahoo...only finding them in the US...would like a canadian provider if possible...thanks


VIPER

still need help with this has anyone done this type of swap, and if so, where did you get the harness>??? I have found it online for 189USD...very expensive...are there any shops or online places that carry this in Canada?????


VIPER

Check your PM.

you can use a p30 obd2a ecu... but there pretty rare
i had one but scott took it off me ;-) better not of sold it 2 him! haha

re pinning is pretty easy actually . just get the right connector and go from there.

I did find the wiring adapter...from florida....the price was 139...plus 10 bux shipping in USD....this was the cheapest that I could find it....if anyone needs the link, let me know...thanks


VIPER