ecu code
#2
does the ecu work?
This one p28 i have gives a code 68 but it won't run my car. It doesn't matter what program i put on the chip, the fuel pump doesn't even prime. Even when i cut the jumper at J1 (with J1 cut the ecu returns to stock...not reading the external ROM).
The sh1tty thing is that i don't know if the ecu was messed when i bought it b/c i didn't try it before i bought it (stupid me). Usually when a shoddy chip job is the problem cutting J1 will make the ecu run the car b/c it returns it to stock.
I've searched till my eyes hurt and never been able to find any info on code 68. If someone could shed a little light on this i would be so grateful.
This one p28 i have gives a code 68 but it won't run my car. It doesn't matter what program i put on the chip, the fuel pump doesn't even prime. Even when i cut the jumper at J1 (with J1 cut the ecu returns to stock...not reading the external ROM).
The sh1tty thing is that i don't know if the ecu was messed when i bought it b/c i didn't try it before i bought it (stupid me). Usually when a shoddy chip job is the problem cutting J1 will make the ecu run the car b/c it returns it to stock.
I've searched till my eyes hurt and never been able to find any info on code 68. If someone could shed a little light on this i would be so grateful.
#5
didn't try........it wasn't my ecu...i was going to buy it but when i put it in my car the engine light came on the he felt it for me to check the code but he pick it up today...i'm going to get a different chip and try it again...i'll keep u posted
Thread
Thread Starter
Forum
Replies
Last Post