dyno tune
#3
Originally posted by Mr. Death
Theres been a few posts latley about this. I'd go with paul @Neetronics. Great guy to deal with and his tunes are great although some people say too conservative..
Theres been a few posts latley about this. I'd go with paul @Neetronics. Great guy to deal with and his tunes are great although some people say too conservative..
#6
pul tuned my car and left a huge 15.5:1 lean spot from 5000 to 6800 rpm right when vtec comes on. i like paul and he is very cool but just leaving the tune like that was disappointing. still i would use him again cause there isnt much else out there that even comes close.
#7
Originally posted by LEITNER
pul tuned my car and left a huge 15.5:1 lean spot from 5000 to 6800 rpm right when vtec comes on. i like paul and he is very cool but just leaving the tune like that was disappointing. still i would use him again cause there isnt much else out there that even comes close.
pul tuned my car and left a huge 15.5:1 lean spot from 5000 to 6800 rpm right when vtec comes on. i like paul and he is very cool but just leaving the tune like that was disappointing. still i would use him again cause there isnt much else out there that even comes close.
He let us do as many runs as we wanted
we filled up the shop with smoke cuz the pipe wasn't long enough to reach your muffler
#8
Paul tuned my car last month with his "conservative tune" which is a little on the rich side but still makes good hp. After he tuned it he said there was still about 10-15 hp left that he could untap if I was unpleased with the power he had made for me. In a nutshell I think Paul would rather give people safe tunes and have them leave happy with a car that is fun to drive and makes good hp with little risk of engine failure. I'm happy with the way my car runs and performs but have booked more dyno time to untap those 10/15 ponies Hp is addictive!
Thread
Thread Starter
Forum
Replies
Last Post
markpa
Honda Civic Performance - JDM Discussion
39
23-Jul-2006 07:03 PM
egproject
Honda Civic Performance - JDM Discussion
10
11-Sep-2003 12:41 PM